Here are the templates needed to build the Omni-Directional Boombox:
These templates are designed to be cut out of 0.175" and 0.5" material. If you used different thickness materials, you will have to modify the templates or parts will not align correctly. Below are the files and their indented material thicknesses:
Electronics Assembly: 0.175"
Speaker Enclosure: 0.175"
Speaker Reflector: 0.175"
Sub Box: 0.5"
Top + Bottom Plate: 0.5"
Forum dedicated to sharing project files such as templates, code, models, etc
1 post • Page 1 of 1
- Josh Hess
- Site Admin
- Posts: 128
- Joined: Sun May 24, 2015 6:00 pm
- Location: Orlando, FL
- Areas of Knowledge: Electronics, Product Design, Manufacturing
- School/University: UCF
You do not have the required permissions to view the files attached to this post.
Science may set limits to knowledge, but should not set limits to imagination.
Who is online
Users browsing this forum: No registered users and 0 guests