Omni-Directional Boombox Templates

Forum dedicated to sharing project files such as templates, code, models, etc
User avatar
Josh Hess
Site Admin
Posts: 129
Joined: Sun May 24, 2015 6:00 pm
Location: Orlando, FL
Areas of Knowledge: Electronics, Product Design, Manufacturing
School/University: UCF

Omni-Directional Boombox Templates

Postby Josh Hess » Sat Mar 12, 2016 6:04 pm

Here are the templates needed to build the Omni-Directional Boombox:
Omni-Directional Boombox Final.zip

Note:
These templates are designed to be cut out of 0.175" and 0.5" material. If you used different thickness materials, you will have to modify the templates or parts will not align correctly. Below are the files and their indented material thicknesses:
Electronics Assembly: 0.175"
Speaker Enclosure: 0.175"
Speaker Reflector: 0.175"
Sub Box: 0.5"
Top + Bottom Plate: 0.5"
You do not have the required permissions to view the files attached to this post.
Science may set limits to knowledge, but should not set limits to imagination.

Return to “Project Files”

Who is online

Users browsing this forum: No registered users and 1 guest