Here are the templates for the 22" Mono Hull boat. The only thing not included in the templates is the jet intake piece as it is specific to the jet that you buy. Inside the zip file, there are two templates, one for the thick wood (1/8 or 1/4 inch) and one for the thin (1/16 or 1/32 inch). I used aircraft grade plywood for added strength, but balsa can be used as well.
Forum dedicated to sharing project files such as templates, code, models, etc
1 post • Page 1 of 1
- Josh Hess
- Site Admin
- Posts: 128
- Joined: Sun May 24, 2015 6:00 pm
- Location: Orlando, FL
- Areas of Knowledge: Electronics, Product Design, Manufacturing
- School/University: UCF
You do not have the required permissions to view the files attached to this post.
Science may set limits to knowledge, but should not set limits to imagination.
Who is online
Users browsing this forum: No registered users and 0 guests