Here are the laser cutting templates for the Mark II EcoSphere:
(Note these will only fit together if quarter inch think material is used)
I will be posting the arduino code once it is finished.
Forum dedicated to sharing project files such as templates, code, models, etc
1 post • Page 1 of 1
- Josh Hess
- Site Admin
- Posts: 126
- Joined: Sun May 24, 2015 6:00 pm
- Location: Orlando, FL
- Areas of Knowledge: Electronics, Product Design, Manufacturing
- School/University: UCF
You do not have the required permissions to view the files attached to this post.
Science may set limits to knowledge, but should not set limits to imagination.
Who is online
Users browsing this forum: No registered users and 1 guest